Ok, I’m done (other than the stand, I’m still pondering what I’ll use).
All in all, I’m happy with how I’ve built this one (with the shims in between the upper and lower saucer and hull parts.
The Round 2 decals are good, but there are some details missing from them (such as some red warning lines for separating saucer, impulse engines etc.). Also missing a couple of little red decals on the saucer top (on each side of the BC decks. Another notible missing decals are saucer and secondary hull edge window decals.
I was able to add all the missing details with decals from Thomas models and Absolute models.
You can see in some of the pictures below, a comparison of the Absolute decals (on my Nebula build), and the ones from round 2. In my opinion, the Round 2 decals are a little too bold for this scale and could be a bit lighter in shade.
What I’d do differently next time? I think I’d definitely airbrush the deflector dish with its paint job, before glueing in place as I’m not that happy with the chalks. I’ve had good success with chalks on the deflector dishes on othe models in the past, but not this one! Also, I’d scan the decals into my computer and lighten them up a little.
I’m still very satisfied with the end result though
Comments/criticism welcome
Andy