Lighting Question
- MEATLOAFr
- Velutinous Vice Admiral
- Posts: 2624
- Joined: Fri Sep 28, 2012 12:46 pm
- Location: Omaha, NE
Lighting Question
Is there any software out there that I can plug in what I'm using (number of bulbs) to tell me what resistors I will need or if I have to much power going thru?
If the world ends tomorrow, it's ALL YOUR FAULT!!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!
- Steam235
- Captain USS December
- Posts: 1265
- Joined: Sun Sep 30, 2012 3:20 am
Re: Lighting Question
There is a website that can tell you what resistor for each LED. but it assumes single LEDs. So if you run your LEDs in Parallel it can really help.
This one might help in other circumstances
https://metku.net/index.html?sect=view&n ... /index_eng
This one might help in other circumstances
https://metku.net/index.html?sect=view&n ... /index_eng
- MEATLOAFr
- Velutinous Vice Admiral
- Posts: 2624
- Joined: Fri Sep 28, 2012 12:46 pm
- Location: Omaha, NE
Re: Lighting Question
thanks, i'll have to take a look at it
If the world ends tomorrow, it's ALL YOUR FAULT!!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!